Knowing your extension table – quick guide


If you own an  original model Oekaki or RS series Toyota sewing machine and have never have used an extension table before, ours can be a little confusing. To make sure you can get it up and running with no fuss, we’ve written you this handy guide!

The first thing most people notice is that the table only has one ‘rubber stopper’ on it. Don’t panic! You aren’t missing three feet, what you actually have is one adjustable screw. The screw in this leg of the table is used to adjust the height of the table to fit your machine (yes, you only need the one!). You may have noticed that table looked too low to fit onto your machine, which is where this adjustable screw comes in.

Caution: We recommend always having the power off when you attach and remove the extension table and accessory box to your machine.

To set your table up on your machine, please follow the steps below:

The extension table has four fold away legs. Before you attach your extension table to your machine you will need to lift up each leg over 90-degrees to the outside until they’re in position. Locate the leg with the adjustable screw.

Turn the screw to adjust the height of the table to reach your desired position. This will level out the up side of the table so it will fit snugly around the free arm of the sewing machine.

Make sure that the measuring line is facing the front of the extension table.

Remove the accessory holder out of your sewing machine, allowing access to the free arm.

Slide the extension table into position around the free arm of the sewing machine until it has clicked into position. You’re now ready to use your extension table!

When you are finished, remove the extension table by sliding it off gently and then reattach your accessory holder.

Enjoy your new-found space for sewing!

Leave a Reply

Your email address will not be published.